|
Relay function (maximum 10
stations) |
You can make a relay with a maximum
of 10 stations using the route
command.
Example of transmitting data (ABCDE)
to the target station with Equipment
ID EI=04 via relay station 1 (EI=02)
and relay station 2 (EI=03).
|
|
Checking the field strength of
target stations |
You can check the field strength (S)
and floor noise level (N) of target
stations from the source station
with commands.
At a golf course, you can
communicate information concerning
carts, sprinklers, lightening alerts
and so on using the relay function.
You can check the field strength of
target stations located at each hole
with commands from the source
station.
With the CR command, you can acquire
the field strength (S) and floor
noise level (N) of specified target
stations.
|
|
Checking communication stability |
By repeatedly executing the packet
communication test command from the
source station, you can measure the
packet success rate.
 |
Competence
in Radio Solution
